Qolsys IQ Panel 2 & 2 Plus - Firmware Update 2.8.1 Release Notes - Dated 11/15/23

TSB #:
231115


DATE:
11/15/23

RE:
IQ PANEL 2 & 2 PLUS - 2.8.1 SOFTWARE UPDATE

RELEASE NOTES & UPDATE INSTRUCTIONS

Release Notes:

New Features:

•
New Setting for PowerG Outdoor Siren (Activation/Comfort LED) allowing the siren’s LED to stay on
continuously.

•
Added a new setting for Force Arming - if a sensor is open during arming, and Force Arm is enabled, if/when
the sensor is restored, after arming is completed, it will become armed along with the rest of the system.

Fixes/Improvements:

•
Added a critical update relating to recovery of cellular connectivity in certain cases where it could become
disconnected from the network.

•
Improved SRF and PowerG daughtercard discovery after panel reboot or software upgrade.

•
Enabled sending and receiving of newer Z-Wave commands supported by Kwikset 620 door lock.

•
Improvements to processing of commands for Schlage Z-Wave door locks.

•
Updated panel icon for iBlinds Z-Wave devices.

•
Corrected an issue that could cause PowerG PIR Cam images to be sent along with the incorrect event if
activated during exit delay.

•
Enhancements to the Solar UI.

•
Corrected behavior for Group 43 & 44 when utilizing EN Grade 2.

•
Corrected an issue that could cause IQ Remotes to not pair properly after updating.

•
Made improvements to ensure that IQ2 panels properly connect to IQ WIFI6.

•
Corrected an issue where the Panel may revert to U.S. Eastern Time Zone (-5 GMT) without an active
Alarm.com account, regardless of local time set on the Panel.

•
General language translation improvements.
Update Instructions:

Compatibility Note: Your IQ Panel must be on software version 2.0.1 or higher and connected to Wi-Fi to install
this update wirelessly. Panels running 2.5.0 & 2.5.1 must be updated to 2.5.3 first, then they can be updated
directly to 2.8.1:

1- Swipe down from the top of the screen and touch “Settings"

2- Touch “Advanced Settings”

3- Enter a valid installer code (default is 1111)

4- Touch "Upgrade Software”

5 -Touch “Patch Tag” and enter the patch
iqpanel2.8.1
then touch OK

6- Touch "Upgrade Using Network" (panel must be connected to Wi-Fi).
 
Update will download and install

7- Once complete touch "OK" to reboot the panel.
 
DO NOT TOUCH THE SCREEN.

 
The update process will
take approximately 5 minutes. After the panel reboots the home screen will appear and the LED will turn green.
TECHNICAL SERVICE BULLETIN
IQ PANEL 2 & 2 PLUS - 2.8.1 SOFTWARE UPDATE - RELEASE NOTES AND INSTRUCTIONS