IQ TSB# 260429 - IQ Pro Update 4.4.1n - Dated 04/29/26
Related Products
Document Transcript
TSB #:
260429
DATE:
04/29/26
RE:
IQ PRO - 4.4.1n SOFTWARE UPDATE - RELEASE NOTES & INSTRUCTIONS
Release Notes:
New Features:
•
Support for the HSM3204CX (Corbus Extender) has been added.
•
New commercial sensor groups have been introduced, including:
•
Group 18: 24Hr Bell/Buzzer
•
Group 23: 24Hr Supervisory
•
Group 24: 24Hr Supervisory Buzzer
•
Group 27: 24Hr Fire Supervisory
•
Group 40: 24Hr Gas
•
Group 48: 24Hr Sprinkler
•
Manual enrollment for MX devices is now supported.
•
Remote diagnostics for Corbus modules are available.
•
Remote enrollment for Prox tags has been implemented.
•
PowerG+ sensor dealer lockdown capabilities have been added.
•
Native support for the following PowerG+ devices is included:
•
PowerG+ IOG Module (PG ID 530 and 106)
•
PowerG+ Indoor PIR Camera (PG ID 145)
•
PowerG+ Smoke/Heat Detector (PG ID 205)
•
PowerG+ Water Tile (PG ID 242)
•
IQ Lock PG (PG ID 502)
•
IQ Light and IQ Dimmer (3-Way)
•
IQ IDP (UK W-Way)
•
Remote over-the-air (OTA) support for Z-Wave devices has been added.
•
Manual enrollment for MX devices is now supported.
•
Remote diagnostics for Corbus modules are available.
•
Remote enrollment for Prox tags has been implemented.
•
Battery gauge reporting for PowerG+ devices is now available on the Alarm.com Partner Portal.
•
A new jam state for water valves on specific Z-Wave shut-off valves has been introduced.
•
Programming options now include the ability to disable the tamper feature on IQ Hardwire PowerG
(PGxWLSHW8/PGxHRDW8) and PGP-IOx modules.
Fixes/Improvements:
•
Fixed an issue where the IQ Installer App could intermittently fail to connect to the IQ Pro panel.
•
Corrected an issue where Firmware updates for the HSM3105MX Module were not applying.
•
Various system enhancements and fixes have been applied.
•
Cybersecurity measures have been updated.
continued on Page 2...
TECHNICAL SERVICE BULLETIN
IQ PRO - 4.4.1n SOFTWARE UPDATE - RELEASE NOTES AND INSTRUCTIONS ...continued from Page 1.
Update Instructions:
Compatibility Note:
Your IQ Pro must be on software version 4.3.0n or higher and connected to Wi-Fi or
Ethernet to install this update.
1- Connect to IQ Pro utilizing the IQ Installer Interface
2- Touch “Configuration”
3- Touch "Upgrade Software"
4- Touch “Patch Tag” and enter the patch
iqpro4.4.1n
5- Touch "Yes, I want to upgrade" (panel must be connected to Wi-Fi or Ethernet). Update will download and
install
6- The update process will take approximately 5 minutes. After the panel reboots reconnect the IQ Installer
Interface
TECHNICAL SERVICE BULLETIN
IQ PRO - 4.4.1n SOFTWARE UPDATE - RELEASE NOTES AND INSTRUCTIONS
- Uploaded