Qolsys IQ Panel 2 Plus 2.3.3 Software Update - Release Notes
TECHNICAL SERVICE BULLETIN
IQ PANEL 2 & 2 PLUS - 2.3.3 SOFTWARE UPDATE
RELEASE NOTES & UPDATE INSTRUCTIONS
Added the ability to get the “Long Sensor ID” from the PowerG daughter card and report it to Alarm.com
Added the ability to get the “Device Firmware Version” from PowerG Sensors if Auto Learned after updating to
2.3.3 and report it to
Added the ability to send Alarm.com the PowerG daughter card radio and modem firmware versions
Compatibility Note: Your IQ Panel must be on software version 2.0.1 or higher and connected to Wi-Fi to install
this update wirelessly.
1- Swipe down from the top of the screen and touch “Settings"
2- Touch “Advanced Settings”
3- Enter a valid installer code (default is 1111)
4- Touch "Upgrade Software"
5 -Touch “Patch Tag” and enter the patch
then touch OK
6- Touch "Upgrade Using Network" (panel must be connected to Wi-Fi).
Update will download and install
7- Once complete touch "OK" to reboot the panel.
DO NOT TOUCH THE SCREEN.
The update process will
take approximately 5 minutes. After the panel reboots the home screen will appear and the LED will turn green.
For more information visit:
IQ PANEL 2 & 2 PLUS - 2.3.3 SOFTWARE UPDATE - RELEASE NOTES AND INSTRUCTIONS