Alarm.com ADC-V724 - How To Factory Default

Factory reset an ADC-V724 to its default settings
Resetting a video device to its factory defaults removes all programming and memory from the device.
Important
: Wait at least two minutes for the video device to power on fully before performing the following procedure.
The factory reset might fail if the device is still powering on.
Rest procedure
Reset button location
Reset button image
1.
Press and hold the WPS/Reset
button until the LED is flashing
green and red (about 15
seconds), then release the
button.
2.
The camera will reboot to
factory default.
Inside the SD card door on the
bottom of the device.
1.
Status LED
2.
SD card door
3.
SD card slot
4.
Speaker
5.
Microphone
6.
WPS/Reset button
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/1080p_Outdoor_Wi-Fi_Camera_wit...
Updated: Mon, 04 Oct 2021 16:29:28 GMT
1 Important
: Once a video device has been reset, it is normal for the LED to turn off momentarily. It is best to leave the
video device plugged into power and undisturbed for two minutes after performing the factory reset.
https://answers.alarm.com/ADC/Partner/Installation_and_Troubleshooting/Video_Devices/1080p_Outdoor_Wi-Fi_Camera_wit...
Updated: Mon, 04 Oct 2021 16:29:28 GMT
2