Honeywell Lyric Alarm System: Batch Enroll Sensors

Honeywell Lyric Alarm System: Batch Enroll Sensors


Transcript

Eddie I was down here with alarmgrid today we are going to be talking about how to do a six series Bachelor moment on the lyric controller what this means it's basically a quick way to program multiple sensors into the panel without going into each specific zone and doing the programming so to start we are going to be going into the security option on the lyric this will then show us the tools option which will show up right here I'm going to press on tools then we're going to enter in our installer code ours is still the default of four one one two we are now in programming so first thing we're gonna do is go into program and then we're going to go into zones now to quickly mention you can see all the zones right here if you did want to do specific zone programming you essentially just tap on with his owns press edit and then you can go in your descriptors your serial number adding and all that for this video we are just going to be doing The Bachelor moment so for the bathroom you see the buttons right here it says start once you press start that turns the late the lyric into its learning mode so for the sensors we have a six series glass break right here when we do in first as you can see there's no battery installed so what I'm gonna do I'm gonna install the battery now sometimes just installing the battery will pick up the sensor as you can see it has not if it did we would get an indication on one of the zones that was picked up in that case I'm going to actually trip the sensor by using its pin its tamper and a press and release and then do that one more time press and release sometimes you have to be there we go so you see it says enter serial number or activate sensor so it's picked it up but it's not fully enrolled it yet so I'm gonna do the tamper one more time and there you go I learned it in now it shows the battery life and it shows the signal strength you do the same thing now with the door contact the door contact already has its battery inside and say it's already installed so I'm gonna take the magnet to the relay on the door contact basically fault the sensor as if we're opening and closing a door give it a couple seconds if anything just try it again and there we go back door activate sensor one last time there you go message is gone away we have our signal strength we are very battery life I'm going to be pressing stop because we're done programming our sensors and that's it that's how you do the bachelor moment it's pretty simple you can then go into the zones if I want to I can press edit say I don't want this to be the backdoor you can change it you can change names anything like that change how it responds if it's perimeter if it's entry eggs if it's one of those door contacts and then yeah that's pretty much a lot of people do that if they have a lot of sensors around saves you time saves a lot of frustration in programming sometimes because you're just doing it quickly and you can just go back and review everything if you did every more questions about programming each either for each zone or for the match enrollment check out our website WWE we're calm and we also have more YouTube videos so if you did like this one please like and subscribe and hit the bell icon to be notified whenever we release more content and if you did have any questions you can also email support at longer comm and give us a call and have a great day


Uploaded