LTEM PA/PV Without Cell: Connecting to WIFI

[AUDIO LOGO] Hi, DIYers. This is Darrell with Alarm Grid. Today we're going to talk about how to connect the LTEM-P Series communicators to your Wi-Fi network without cellular. To start off, we're going to verify that the Wi-Fi module is installed in your unit. To open the unit we're going to press the two tabs at the bottom opening up the case and we're going to verify that the Wi-Fi module is installed in the top left of the LTEM communicator, which is here. If you do not have this module, you may need to purchase the module and install it using another video we have. We're using the Android app to connect to the LTEM-P communicator. We're going to press total connect 2.0, the icon on there. From there we're going to press the three-line menu, we're going to go to Settings, we're going to see the change device Wi-Fi network. Let's tap that. It's going to ask if you have access to the LTEM-P communicator. For this one we're going to answer yes to turn the Bluetooth on manually. We're going to go to your LTEM-P, we're going to find the red test button, we're going to press and hold that for three seconds and release. That will start the Bluetooth pairing mode where LEDs 1, 3, and 5 will all blink at the same time. And then we'll hit Next on our mobile device. Make sure your Bluetooth is turned on your phone. Once you verify that the Bluetooth is turned on go to next. It should find your LTEM-P communicator. Verify the last three of the MAC address match just to be safe that you've got the right one and there's somebody else not trying to do the same thing somewhere near you. We will tap the LTEM-P from the list. It'll fetch the Wi-Fi list of all the available networks near you. Once you see your list of Wi-Fi networks, select the one that you will be using to connect to the Wi-Fi. Then press Next. Enter your password for your Wi-Fi network. Once you've entered your Wi-Fi network password press Next and you have successfully set up the Wi-Fi network. Hit Done and then check with your technician to make sure the Fi network is working properly. This ends the Android app setup. Don't forget, once you've connected your Wi-Fi to close your LTEM-P communicator. OK, DIYers. And that's how you connect the LTEM-P series communicators to your Wi-Fi without cellular. If you have any questions, send us an email to support@alarm.com or head to our website alarmgrid.com. If you found the video helpful please like, and subscribe and hit the bell icon for future notifications. This is Darrell with Alarm Grid. Have a great day.