AlarmNet Communicator ECP Status Codes
Created on 08/29/06
Page 1 of 1
ECP Status Codes
When the Communicator
is configured for ECP mode, it sends status messages to the control
for battery, power, tamper, and network connectivity failures. Some of the control
-15P and VISTA
-20P Series) display these on the keypad as
followed by a 4-
. In addition, the C
codes for these conditions are sent to the
central station by the
ECP Keypad Displays Status Codes
ntrol panel lost communication with 7845i
tamper detected (cover removed).
has lost contact with AlarmNet
has lost contact with AlarmNet.
is not registered; accou
nt not activated.
-on reset AND the panel lost communications with
power on reset AND tamper detected.
power on reset AND tamper detected AND not reg
tamper detected and 7845i
-GSM battery low.
Primary power loss (will only be displayed in conjunction with another event).
Battery charger failure (will only be displayed in conjunction with another
Low battery (will only be displayed in conjunction with another event).
Central Station Messages