Honeywell LYNXRCHKIT-SC, LYNXYRCHKIT-HC, LYNXRCHKIT-SHA Installation Manual and Setup Guide

LYNXRCHKIT-SC, LYNXRCHKIT-HC AND LYNXRCHKIT-SHA RECHARGEABLE BATTERY KITS INSTALLATION INSTRUCTIONS
GENERAL INFORMATION
The LYNXRCHKIT-SC, LYNXRCHKIT-HC and LYNXRCHKIT-SHA rechargeable battery kits are designed to replace the rechargeable battery installed in the LYNXR-EN/LYNXR-ENSIA, LYNXRI/LYNXR-ISIA series control panels. When battery replacement is required, perform the following steps. STEP 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. ACTION Unplug the transformer from the wall outlet and open the control panel cover. Remove the battery retainer and disconnect the battery pack connector from the receptacle on the terminal block PC board. Refer to Figure 1 for the LYNXR-EN or Figure 2 for the LYNXR-I. Remove the battery pack from the back plate. Replace tape on back plate assembly (if necessary). Install the battery pack in the back plate. Refer to Figure 1 for the LYNXR-EN or Figure 2 for the LYNXR-I. Install the battery retainer. Connect the battery connector to the receptacle on the terminal block PC board. After the wiring connection has been made, snap the front assembly to the back plate. Plug the transformer into a 24-hour, 110VAC unswitched outlet. Rechargeable batteries may take up to 48-hours to fully charge. The “LOW BAT” message should clear within four hours or by entering Test Mode. Ensure the control panel cover is closed prior to applying AC power.
LYNXRCHKIT-HC RETAINER OR LYNXRCHKIT-SC

BATTERY PACK

BATTERY CONNECTOR

TAPE

BATTERY RECEPTACLE

MXX X K51 X 08

01009-006-V0

Figure 1 – Replacing the LYNXR-EN Battery pack

LYNXRCHKIT-HC
RETAINER

OR

LYNXRCHKIT-SC

BATTERY PACK

TAPE BATTERY CONNECTOR

BATTERY RECEPTACLE

LYNXRCHKIT-SHA
RETAINER

BATTERY PACK

BATTERY CONNECTOR

TAPE

BATTERY RECEPTACLE

07000-006-V1

Figure 2 – Replacing the LYNXR-I Battery pack

165 Eileen Way, Syosset, New York 11791
Copyright © 2006 Honeywell International Inc. www.honeywell.com/security

‡K4179-1V1ÀŠ
K4179-1V1 9/06 Rev. A