How to Factory Reset an ADC-VC736 - User Guide

Factory reset an ADC-VC736 to its default settings
It is recommended that the device be powered on for at least two
minutes before trying to factory reset it.
Important
: If the factory reset is attempted immediately after power up it will not work as the device will still be
rebooting. After performing a factory reset, it is strongly recommended to leave the device alone and plugged into power
for two
minutes.
Reset Procedure
ADC-VC736 image
1.
Disconnect the camera from the power supply.
2.
Use a Phillips-head screwdriver to remove the
water-tight door (see diagram).
3.
Press and hold the Reset button while
reconnecting power. Continue to hold the Reset
button for 10 seconds.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Bullet_Camera_(ADC-VC736)/Factory_reset_an_ADC-VC736_to_its_default_settings
Updated: Fri, 31 Aug 2018 17:12:26 GMT
1 Important
: If the camera was previously installed on an Alarm.com account, it will need to be deleted before it can be
installed again.
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/Indoor%2F%2FOutdoor_Bullet_Camera_(ADC-VC736)/Factory_reset_an_ADC-VC736_to_its_default_settings
Updated: Fri, 31 Aug 2018 17:12:26 GMT
2