2GIG RPTR1-345

Wireless Repeater

2gig rptr1 345 wireless repeater

Average rating:

(based upon 0 reviews)

The 2GIG RPTR1-345 is a wireless repeater that works with 2Gig's GC3 and GC2 panels to extend the range or provide an alternate signaling...
List Price
Our Price
You Save
$15.01 (19%)


The 2GIG RPTR1-345 is a wireless repeater that works with 2Gig's GC3 and GC2 panels to extend the range or provide an alternate signaling path for both Honeywell 5800 Series and 2GIG wireless RF sensors. You can use multiple repeaters with one system but you can't send signals through more than one repeater when traveling back to the system. Also, a single repeater can accept signals from as many sensors as there may in within range to the repeater. The repeater should be mounted high on a wall to get best reception to all sensors in range.

The repeater works with all GC3 panel firmware versions but if you want the option to supervise the repeater for low battery, tamper and power loss conditions, the GC3 panel must be running firmware version 3.1 or higher. For GC2 panels, the repeater only works with firmware versions 1.14 or higher. The zone programming needed for the supervision conditions is not required on either system as the device will automatically pass along any Honeywell 5800 Series or 2GIG wireless sensor signals that are in range to the repeater to any compatible 2GIG system that is in range to the repeater.

The repeater includes a 24-hour backup battery and the power supply needed to power the unit that plugs into a standard wall outlet. The wire to connect the power supply to the repeater is not included but you can use the LT-CABLE if your outlet is within eight feet of where you plan to mount your repeater.

Note: The 2GIG RPTR1-345 will not repeat the signal for bi-directional (2-way) communication devices like the Honeywell 5828 Keypad and the 5800WAVE Siren. Keep this in mind when system planning.


2GIG RPTR1-345 Compatible Products

Wireless Door/Window Contact with Push-Button Bypass
List Price: $44.00
Our Price: $27.99
Factory Packaged GC3, 3 wireless door/window sensors, 1 wireless motion, and a key fob kit
List Price: $738.00
Our Price: $399.99
Wireless Repeater for Honeywell and 2GIG
No, as this only works for 2Gig and Honeywell 5800 Series sensors that use the 345 Mhz range, it wouldn't boost signaling from a Lyric to a SiX sensor. There currently is no repeater option for SiX devices but as SiX devices should work up to 300' from the panel and 5800 Series sensors should work 200' from the panel, using this repeater or the Honeywell 5800RP (https://www.alarmgrid.com/products/honeywell-5800rp ) would give you up to 400' range so you could swap out a SiX device that is too far away and replace it with a 5800 Series device using a repeater.
Will this work with the newer Honeywell systems (SiX)? Thanks
* Based on a 10% APR with 12 months financing. APR's will vary between 10% - 30% based on credit score and various factors.