How Do I Factory Reset an ADC-V723 to Default?

You can factory reset an ADC-V723 to default by pressing and holding the Reset/WPS button on the bottom of the device until the LED light is flashing red and green. You can release the button at that point. The process usually takes about 15 seconds. You should confirm the reset afterward.

By resetting the ADC-V723, its programming settings and device memory will be deleted. You will need to reprogram the ADC-V723 Outdoor Camera with Alarm.com. Additionally, Alarm.com may still believe that the camera is paired with its servers. You should also delete the camera from the platform when you have the chance. You will need to re-pair the ADC-V723 if you intend to continue using it with your account.

Performing a factory default is generally only performed if there is something seriously wrong with the device. In that sense, it represents a last resort troubleshooting method. You might also factory default an Alarm.com ADC-V723 Camera if you are planning on selling it or using it with a different Alarm.com account for whatever reason. Otherwise, there is little reason to factory default this device.

Please note that after the reset has been performed, the LED light may briefly turn off. This is normal, and it does not mean that anything is wrong with the device. You should leave the device plugged in for at least two (2) minutes following the reset. It is best to not disturb the camera during this two (2) minute period.

Complete the following steps to factory default an Alarm.com ADC-V723 Outdoor Camera:

1. Press the reset button. Locate the reset button on the bottom of the Alarm.com ADC-V723. This is also the WPS button for the device. Press the button, and keep it held down.

2. Wait for the reset. Keep holding down the button until the LED lights flash red and green. This will take about 15 seconds. You can then release the button. This will perform the factory reset.

3. Confirm the reset. After the reset, the LED light may turn off for a short period of time. However, it should come back on shortly thereafter. The device should be left plugged in and undisturbed for at least two (2) minutes following the factory reset. You will know that the reset was successful because you will need to re-add the device to an Alarm.com account.