Honeywell L5200 Frequently Asked Questions

How Do I Register the Honeywell 3GL?
A Honeywell 3GL cellular communicator can be registered remotely by an alarm monitoring company, or it can be registered on-site at the security panel.
Added:

How Do I Program a Wireless Sensor on my Honeywell LYNX Touch?
Wireless sensors can be programmed to a LYNX Touch system through the panel's zone programming menu. You will need the installer code to access the menu.
Added:

How Do I Know Which LYNX Panel I Have?
The easiest way to tell which Lynx Panel you have is by visually identifying it. Each Lynx panel has certain visual clues that can be used to identify it.
Added:

How Do I Replace an Existing 5816 On My Lynx Touch?
You can replace an existing 5816 by removing it from panel programming, and then uninstalling it from its location. Then program the new 5816 and install it.
Added:

How Do I Activate a Honeywell 5800PIR-RES for Lyric or Lynx Panels
You can activate a Honeywell 5800PIR-RES by programming it into your Honeywell panel. Once activated, make sure to test the sensor in its final location.
Added:

How Do I Delete a Zone from My Lynx Touch or Lyric Panel?
A zone can be deleted in the programming menu of the panel. This is useful for when you no longer intend to use a wireless device with the security system.
Added:

How do I Setup the Honeywell 5800PIR-RES on a Lynx Touch?
In order to setup a Honeywell 5800PIR-RES motion detector, you must first program the sensor into your security panel and then install it onto a wall.
Added:

How Do I Cut the Time Delay on My Honeywell Lynx Touch Alarm System?
In order to cut the time delay on a Honeywell alarm system, the user must access the program menu and adjust the entry and exit delays to the desired length.
Added:

How Do I Register the 3GL Cellular Module on an L5200?
To register the 3GL cellular module on an L5200, you must contact your alarm monitoring company and provide them with the MAC and CRC of the communicator.
Added:

Why Won't My Honeywell L5200 Disarm?
The most common reason for an L5200 to not disarm is because the wrong user code is being entered. Check and make sure the correct code is being entered.
Added: