Ubiquiti Corrects Issue With UniFi Access Points
Posted By Michael GorisAccording to reports, Ubiquiti has corrected an issue affecting their UniFi Access Points (APs). Alarm Grid previously reported the issue back in February. The issue prevented various security systems from connecting. Users had to disable the Auto Optimize Network feature to connect.
It is our understanding that Ubiquiti pushed a firmware update to their UniFi Access Point devices. This firmware update made it so that a security system will not be booted from the network when the Auto Optimize Network feature is enabled for the AP. Users can now expect their systems to work while the AP is in this mode.
Before the issue was fixed, we were only aware of Honeywell Lyric Alarm Systems being affected. We later learned that other systems connecting with Ubiquity UniFi Access Points were believed to be affected as well. Regardless, there should no longer be any issues when using a UniFi AP with your system, as long as the AP received the firmware update.
If you are still experiencing issues, we recommend emailing us at support@alarmgrid.com. While we cannot push the update to an Ubiquiti AP, we can walk you through steps for making sure that your alarm system is doing its part. We check our email from 9am to 8pm ET M-F. Also make sure to check out our monitoring page if you are interested in learning more about our services. We look forward to hearing from you!
Update: The Honeywell ProSeries Panels (PROA7PLUS, PROA7PLUSC, PROA7, and PROA7C), when used with Ubiquiti Access Points, require that an Ubiquiti device has its Auto-Optimize feature turned OFF. This is needed for maintaining a stable WIFI connection. Please keep this in mind if you use an Ubiquiti Access Point with a ProSeries System.
